
PCB & Electronics
Ultrasonic cleaning for connectors, terminals, stamped conductive parts, PCBs and FPCs, heat-dissipation parts and machined housings — flux, oil and fine particulate out of blind holes and slits.
Every industry brings its own workpieces and its own contamination. Start with yours to see the parts we clean, the contaminants we remove and the frequency we recommend.


Ultrasonic cleaning for connectors, terminals, stamped conductive parts, PCBs and FPCs, heat-dissipation parts and machined housings — flux, oil and fine particulate out of blind holes and slits.

Ultrasonic cleaning and centrifugal drying for silicon wafers, solar panels, quartz carriers and chamber hardware — 40, 80 and 120 kHz in one tank where the process needs all three.

Ultrasonic cleaning for optical glass, resin spectacle lenses, contact lenses, phone cover glass and camera modules — and the pre-ovens, drying ovens and hardening machines around them.

Ultrasonic cleaning for stamped parts, machined components, bearings, motor housings and steel tube — single tanks through to nine-stage automated lines with air-knife blow-off and drying.

Ultrasonic cleaning for surgical instruments (including da Vinci instruments), dental and orthopaedic implants, device components and glass vials — from 6 L benchtop units to nine-stage automated lines.

Ultrasonic and high-pressure spray cleaning for spinnerets, candle filters, spin packs and textile machine parts — clearing polymer residue from holes as fine as 50 microns.

Ultrasonic and electrolysis cleaning for injection, die-cast, stamping and food moulds — carbon, gas residue, rust and release agent lifted off a cavity by non-contact cleaning.

Ultrasonic dishwashers, produce washers and mould cleaning for commercial kitchens and food plants — cavitation reaches every surface evenly, lifting grease, baked-on residue and grit.

Ultrasonic cleaning for aerospace maintenance and component manufacturing — starting with the single-tank lift-type machine LEO built for aircraft wheel rims.

Ultrasonic cleaning for vehicle maintenance and automotive component manufacturing — carbon and oil off engine parts, forming oil off stamped and machined components.

Ultrasonic cleaning for additive manufacturing — uncured resin off SLA parts, residual powder out of SLS and metal AM lattices, and cured build-up off plates and nozzles.

What ultrasonic cleaning does for marine engineering — mainly filter elements, plus carbon, salt scale and oil sludge off engine components, heat exchangers and fuel system parts.
Tell us what you need cleaned
Send us the part, the contaminant and your cycle time. Our engineers size the tank, the frequency and the process chain — and reply with a sized specification for your line.