
PCB & Electronics
Ultrasonic cleaning for connectors, terminals, stamped conductive parts, PCBs and FPCs, heat-dissipation parts and machined housings — flux, oil and fine particulate out of blind holes and slits.
Turned, milled and drilled parts arrive carrying the fluid they were cut with, plus the swarf that fluid held against the metal. Blind holes, cross-drillings and thread roots are where it stays, and they are the geometry a spray simply travels past.

| Workpieces & contamination | What has to come off | Recommended frequency | Documented under |
|---|---|---|---|
| CNC-machined electronic housings | 40 kHz | PCB & Electronics | |
| Other precision metal parts | 40 kHz | PCB & Electronics | |
| CNC-machined components | 40 kHz | Precision Machining & Metal Stamping | |
| Motor and servo motor housings | 28 / 40 kHz | Precision Machining & Metal Stamping | |
| Steel tube and pipe | 28 kHz | Precision Machining & Metal Stamping | |
| Zips and small hardware | 40 kHz | Precision Machining & Metal Stamping | |
| Pen nibs and micro-turned parts | 40 / 80 kHz | Precision Machining & Metal Stamping | |
| Parts before plating or coating | 40 kHz | Precision Machining & Metal Stamping | |
| Enclosures and case shells | 28 / 40 kHz | Precision Machining & Metal Stamping | |
| Machined structural components | 40 kHz | Aerospace | |
| Fasteners and small hardware | 40 kHz | Aerospace | |
| Pumps, valves and pipe fittings | 28 / 40 kHz | Marine |

Ultrasonic cleaning for connectors, terminals, stamped conductive parts, PCBs and FPCs, heat-dissipation parts and machined housings — flux, oil and fine particulate out of blind holes and slits.

Ultrasonic cleaning for stamped parts, machined components, bearings, motor housings and steel tube — single tanks through to nine-stage automated lines with air-knife blow-off and drying.

Ultrasonic cleaning for aerospace maintenance and component manufacturing — starting with the single-tank lift-type machine LEO built for aircraft wheel rims.

What ultrasonic cleaning does for marine engineering — mainly filter elements, plus carbon, salt scale and oil sludge off engine components, heat exchangers and fuel system parts.
Tell us what you need cleaned
Send us the part, the contaminant and your cycle time. Our engineers size the tank, the frequency and the process chain — and reply with a sized specification for your line.