Skip to content
Skip to content

PCBs and electronic assemblies

Boards and populated assemblies are cleaned to remove flux residue that stays chemically active after soldering. The residue that matters is the residue you cannot see — under BGAs, beneath chip components and inside connector housings, where a spray stops at the first obstruction.

Close-up of printed circuit board traces and solder pads

Parts in this family

Workpieces & contaminationWhat has to come offRecommended frequencyDocumented under
Connectors
Machining oilOxidesMachining residues
40 / 80 kHzPCB & Electronics
Terminals40 kHzPCB & Electronics
Stamped conductive parts28 / 40 kHzPCB & Electronics
Precision electronic components
Microscopic residuesFluxMachining residues
80 / 120 kHzPCB & Electronics
PCBs and FPCs40 kHzPCB & Electronics
Heat-dissipation parts
Machining oilMachining residuesThermal compound
40 kHzPCB & Electronics
Micro parts — through holes, slits, deep holes80 / 120 kHzPCB & Electronics
Assembled electronic components
Assembly fluxOilsHandling residue
40 / 80 kHzPCB & Electronics
Marine electronics and control boards40 kHzMarine
Technology

Recommended frequency

40 / 80 kHz
40 kHz
28 / 40 kHz
80 / 120 kHz
Industries

Industries that clean these parts

Close-up of printed circuit board traces and solder pads

PCB & Electronics

Ultrasonic cleaning for connectors, terminals, stamped conductive parts, PCBs and FPCs, heat-dissipation parts and machined housings — flux, oil and fine particulate out of blind holes and slits.

Learn more
Aerial view of a container ship under way, trailing a white wake

Marine

What ultrasonic cleaning does for marine engineering — mainly filter elements, plus carbon, salt scale and oil sludge off engine components, heat exchangers and fuel system parts.

Learn more
Request a Quote

Tell us what you need cleaned

Send us the part, the contaminant and your cycle time. Our engineers size the tank, the frequency and the process chain — and reply with a sized specification for your line.

LINEPhoneRequest a Quote